Backing Pads

BACKING PAD 100MM X 5/8 UNC FOR STONE POLISHING....

Backing pad Polishing backing pad with M14 thread. For concave wool bonnets. DIA: 150mm (6') HOLES: No THREAD: M14 hook & loop: Yes with offset Application: This is a replacement backing pad for a polisher with M14 fastening thread. There is a hook & loop offset to minimise damage from the sharp hook & loop edge. The backing pad is ideal for concave polishing bonnets. Attention: Wear eye, face & body protection....

INTERFACE CUSHION PAD 150MM HOOK AND LOOP 6 HOLES....

Backing pad for angle grinder Backing pad to be used with an angle grinder with M14 thread. DIA: 115mm THREAD: M14 Hook & Loop: No DENSITY: Hard MAX RPM: 11,500 Application: This is a backing pad for an angle grinder to use fibre discs. The range of fibre discs can be viewed here. CAUTION: Due to the high rotation speed of angle grinders, it is not recommended to use polishing bonnets with this backing pad. ATTENTION: Wear eye, face & body protection....

Backing pad Rubber backing pad to be used with a drill DIA: 125mm (5') HOLES: No ARBOR: &O/;6mm Hook & Loop: No Application: This is a backing pad for fibre discs or polishing bonnets. The backing pad is fitted with an arbor to be used with electric or cordless drills. The rubber is flexible & allows  for flat or contoured s&ing without gouging. Attention: Wear eye, face & body protection....

TorkCraft - Screw Type Backing Pad Kit Size: 50 mm Application: S&ing & surface conditioning discs are good for removal of metal burs, paint, rust & finishing applications. Worls well on Die-grinders & electric drills. Quick change replacement screw type backing pad Arbot included Use with screw type back pad TCFA03007 WARNING: Using any tool can be dangerous. Always select the right tool for the job. NOTE: Use with screw type backing pad TCFA03007....

Flange spanner Application: A flange spanner is used to remove the outer flange on an angle grinder to replace or change the abrasive grinding disc. The measurements of the pins on the flange spanner is: 35 x &O/;4mm....

Adjustable Pin Spanner for Angle Grinder - 15-52 x 4mm Pin Centers: 15 - 52mm Too big - too small, adjust the fit. Tork Craft's adjustable pin spanner is designed to fit most Angle grinder flange nuts & more with pin hole diameters of 4mm, ranging from 15mm-52mm centre to centre pin spacing. At the bottom end of the spanner is a flat tip allowing for easy paint can opening as well as built into the h&le is a basic wrench with sizes 10,12,13,14,15,17,19mm. This 3-in-1 tool ..

Festool S&ing pad ST-D180/0-M14/2F Order number: FES485296 Model: ST-D180/0-M14/2F ....

Angle Grinder Pad - &O/; 115mm M14 White backing pad The backing pad is made of Nylon & provides support to abrasive s&ing/grinding discs. The backing pad is considered for universal use & has a medium flexibility. The supplied lock nut securely holds the abrasive in place. Select a backing pad diameter close to the abrasive diameter, but not greater. This will be ideal when working on irregular surfaces.....